Port) interface configuration – Comtrol ES8509-XT User Manual
Page 138
138 - (Port) Interface Configuration
RocketLinx ES8509-XT User Guide: 2000557 Rev. C
Configuration Using the Command Line Interface (CLI)
(Port) Interface Configuration
When you type interface IFNAME in Global Configuration mode, you can access Interface Configuration mode.
In this mode you can configure port settings.
The port interface names for Gigabit Ethernet port are gi1 through gi9.
Type the following commands and press the Enter key:
•
exit to return to Privileged EXEC mode.
•
? to see the command list.
•
list to review the Interface Configuration mode commands and corresponding options. The following list is
the available commands for the Port Interface Configuration mode.
For the complete list of commands and options, refer to
Port Interface Configuration Mode
Switch(config)# interface gi1
Switch(config-if)#
acceptable Configure 802.1Q acceptable frame types of a port
auto-negotiation Enable auto-negotiation state of a given port
description Interface specific description
dot1x IEEE 802.1x standard access security control
duplex Specify duplex mode of operation for a port
end End current mode and change to enable mode
exit Exit current mode and down to previous mode
flowcontrol Set flow-control value for an interface
garp General Attribute Registration Protocol
ingress IEEE 802.1Q ingress filtering features
lacp Link Aggregation Control Protocol
list Print command list
loopback Specify loopback mode of operation for a port
mdix Enable mdix state of a given port
mtu Specifies the MTU on a port
no Negate a command or set its defaults
qos Quality of Service (QoS)
quit Exit current mode and down to previous mode
rate-limit Rate limit configuration
sfp Small form-factor pluggable
shutdown Shutdown the selected interface
spanning-tree spanning-tree protocol
speed Specify the speed of a Fast Ethernet port or a
Gigabit Ethernet port
switchport Set switching mode characteristics