Chrysler 2015 Country - User Guide - Manual (Page 16)

3. Push the ENGINE START/STOP button a third time to return the ignition to the OFF
position.
NOTE:
If the ignition is left in the ACC or ON/RUN
(engine not running) position and the transmis-
sion is in PARK, the system will automatically
time out after 30 minutes of inactivity, and the
ignition is returned to the OFF position.
VEHICLE SECURITY ALARM
The Vehicle Security Alarm monitors the vehicle doors for unauthorized entry and the ENGINE
START/STOP button for unauthorized operation. While the Vehicle Security Alarm is armed,
interior switches for door locks and decklid release are disabled. If something triggers the alarm,
the Vehicle Security Alarm will provide the following audible and visible signals: the horn will
pulse, the park lamps and/or turn signals will flash, and the Vehicle Security Light in the
instrument cluster will flash.
To Arm
• Keyless Enter-N-Go™ button installed: Push the Keyless Enter-N-Go™ START/STOP
button until the Electronic Vehicle Information Center (EVIC) indicates that the vehicle
ignition is “OFF.” Push the power door LOCK switch while the door is open, push the Key Fob
LOCK button, or with one of the Key Fobs located outside the vehicle, and within 5 ft (1.5 m)
of the driver's and passenger front door handles, push the Keyless Enter-N-Go™ LOCK
button located on the door handle.
• Keyless Enter-N-Go™ button not installed: Turn the ignition switch to the “OFF” position.
Push the power door lock switch while the door is open, push the Key Fob LOCK button with
one of the Key Fobs located outside the vehicle and within 5 ft (1.5 m) of the driver's and
passenger front door handles.
NOTE:
After pushing the Keyless Enter-N-Go™ LOCK button, you must wait two seconds before you
can lock or unlock the vehicle via the door handle.
Ignition Positions
G E T T I N G S TA R T E D
14