Chrysler 2015 Country - User Guide - Manual (Page 14)

NOTE:
• If “Unlock All Doors 1st Press” is programmed, all doors will unlock when you grab hold of the front
driver's door handle. To select between “Unlock Driver Door 1st Press” and “Unlock All Doors 1st
Press,” refer to the “Electronic Vehicle Information Center (EVIC)” in your vehicles Owner's
Manual on the DVD or “Programmable Features” in this guide for further information.
• If “Unlock All Doors 1st Press” is programmed, all doors and liftgate will unlock when you push
the liftgate button. If “Unlock Driver Door 1st Press” is programmed, only the liftgate will
unlock when you push the liftgate button. To select between “Unlock Driver Door 1st Press”
and “Unlock All Doors 1st Press,” refer to the “Electronic Vehicle Information Center (EVIC)”
in your vehicles Owner's Manual on the DVD or “Programmable Features” in this guide for
further information.
• If a Key Fob is detected in the vehicle when locking the vehicle using the power door lock
switch, the doors and liftgate will unlock, and the horn will chirp three times. On the third
attempt, your Key Fob can be locked inside the vehicle.
• After pushing the Keyless Enter-N-Go™ LOCK button, you must wait two seconds before you
can lock or unlock the vehicle using the door handle. This is done to allow you to check if the
vehicle is locked by pulling the door handle without the vehicle reacting and unlocking.
• If a Keyless Enter-N-Go™ door handle has not been used for 72 hours, the Keyless Enter-N-
Go™ feature for that handle may time out. Pulling the deactivated front door handle will
reactivate the door handle's Keyless Enter-N-Go™ feature.
Lock Or Unlock The Liftgate:
• With a valid Passive Entry RKE transmitter within 5 ft (1.5 m) of the liftgate, cycle the handle
to open the liftgate and pull the liftgate open with one fluid motion.
NOTE:
• All doors will remain locked when the liftgate release handle is pushed regardless of the driver’s
door unlock preference setting (“Unlock Driver Door 1st Press” or “Unlock All Doors 1st
Press”).
• Refer to “Keyless Enter-N-Go” in “Things To Know Before Starting” located in your Owner's
Manual on the DVD for further information.
Installing And Removing The ENGINE START/STOP Button
Installing The Button
• Remove the Key Fob from the ignition switch.
• Insert the ENGINE START/STOP button into the ignition switch with the lettering facing up
and readable.
• Push firmly on the center of the button to secure it into position.
G E T T I N G S TA R T E D
12