RCA RCU400R3 - Manual (Page 14)

Custom TV (Systemlink Exclusive)
The CUSTOM button allows you to store 10 of your
favorite TV channels in memory. You can access these chan­
nels using the remote's number buttons. Follow the steps
below to program channels to each of the number buttons.
Programming the Custom Button
1 . Press and hold CUSTOM.
PRESS
&H0LD
CUSTOM
2. Press the number (0-9) you want
to use to bring up the custom
channel. For example, if you
want to program channel 12 to
the number 1 button, press 1.
3. Enter the channel number as you
would normally. Up to three but­
tons may be pressed, including
the ENTER button.
4. Release CUSTOM. The Custom
button will flash once if pro­
gramming was successful.
If it does not flash, it was not
programmed. Try again.
5. Repeat steps 1-4 for each addi­
tional channel.
ENTER 0/-—X
RELEASE
CUSTOM
Using the CUSTOM feature
1. Press and release CUSTOM.
CUSTOM
2. Press a number button to bring
up the Custom charmel pro­
grammed. Custom wUl flash if
the button has been programmed.
There wiU be a slight delay as
channels change, so be sure to
hold the number button down
vmtil the charmel changes.
3. The CHANNEL UP or DOWN
keys can now be used to cycle
through all programmed
number buttons while in the
Custom mode.
To Turn off the Custom Feature
Press any device button (TV,
VCR, CABLE, AUX) to exit
the remote from the Custom
mode and place it in normal
operating mode.
0^
CHAN
AUX CABLE VCR TV
0 0 0 0
14