RCA 15491880 - Manual (Page 25)

Using the Remote Control
Tip
To turn off all the
RCA, GE. and
PROSCAN
components that are
connected to the TV,
press ON-OFF twice
within two seconds.
This feature only
works with most RCA,
GE and PROSCAN
products.
PAUSE If you’re operating a VCR or DVD Player with the remote control, press PAUSE when the di.sc
or videotape is playing to patise playback.
PLAY If yon'ie operating a VCR or DVD Player, plays the disc or videotape.
REC»VCR+ When the GUIDE Plu.s+ program gtiide is on the screen, press REC*VCR+ to program
yoLir VCR to record a program. If the remote is in VCR mode, pre.ss REC-VCR+ to start recording.
REVERSE If you're operating a VCR or DVD Player with the remote control, pre.ss REVERSE to go
backwards on a di.sc or videotape.
SAT»CABLE Puts the remote in SAT»CABLF. mode. If you set up the Auto Tuning feature (Chapter
3), pre.ssing the SAT*CABLE button auttjmatically tunes the TV tt) the correct channel.
SKIP If you pre.ss this button befttre you change the channel, the TV waits 30 seconds and
automatically goes back to the ttriginal channel. Each time you pre.ss SKIP, you add 30 seconds (i.e. if
you press SKIP two times before you change the channel, the TV waits 60 seconds and automatically
turns back to the original channel).
SOUND Di.splays the AUDIO PROCESSOR menu.
STOP If you’re operating a VCR or DVD Player, stops playing the disc or videotape.
TV Turns on the TV and puts the remote in TV mode. Also displays channel information.
VCRl Puts the remote in VCR mode. If you set up the Auto Tuning feature (Chapter 3), pressing the
VCRl button automatically tunes the TV to the correct channel.
VCR2 Puts the remote in VCR mode. If you set up the Auto Tuning feature (Chapter 3), pressing the
VCR2 button automatically tunes the TV to the correct channel.
VOL (up and down) buttons Decrease or increase the TV’s volume.
’WHO*INPUT In TV mode, press WHO»INPUT to toggle through the available Video Input channels
(VID/SVID and the current channel). In SAT mode, press to select available channel lists.
Using the WHO*INPUT Button
Use the WHO*INPUT button to toggle through the available input sources (VID and the current
channel) and view the content from the component you have connected to the TV.
1. Press TV to place the remote in TV mode. Make sure that the content from the component is
turned ON,
2. Press WHO*INPUT to tune to the available input source and view the component.
3. Press WHO*INPUT again to tune back to the channel you were previously watching.
Chapter 2
23