Toshiba MA-68 SERIES - Manual (Page 32)

REPLACING INK ROLLER:
When the print content becomes too light to read, replace the ink roller
with a new one.
1. Remove the Receipt Cover.
2 , P u l l u p t h e r e a r p l a s t i c e d g e o f
t h e p r i n t e r ( b 1 a c k - c 1 o r e d ) t o u n ­
l o c k t h e s t o p p e r s ( w h i t e - c o l o r e d )
w h i l e p r e s s i n g t h e p l a s t i c l e v e r s
r e a r - w a r d ( w h i t e - c o l o r e d ) o n b o t h
s i d e s o f t h e P r i n t e r H o l d e r t h a t
i s f i x e d o n t h e d r a w e r u n i t . ( O n e
l e v e r a t a t i m e w i l l e a s e u n d o c k ­
i n g . ) ( F i g . 6 )
3, Let the Printer Unit stand upright
as shown in Fig.6. (Do not attempt
to remove the unit entirely from
the holder otherwise, the attached
cables might be damaged.) The Ink
Roller is set in the middle of the
'bottom of the unit.
4, Turn the plastic protrusion of the
roller upward and pull it off. Now
it is removed from the Ink Roll
Holder. (Fig,7)
5 . F o r i n s t a l l i n g a n e w I n k R o l l e r ,
f o l l o w t h e r e m o v i n g o p e r a t i o n s i n
r e v e r s e o r d e r ,
NOTES; 1) To install a new ink roller,
push it all the way into
the Ink Roll Holder and
release the protrusion
as it will swing into the
correct position by the
spring . (F ig,8 )
2) Set the Printer Unit all
the way into the Print
Unit Holder. When it is
settle correctly, a "click"
is heard.
- 28 -