Communication port on the cpu module, Free ascii mode, Data link mode – Toshiba T2E User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Communication Port on the CPU Module
Free ASCII mode
User defined ASCII messages can be transmitted
and received through this port. A termini, printer,
bar-code reader, or other serial ASCII device can be
directly connected.
Шз mode allows the T2E/T2N to communicate with
other PLCs 0Г1, T2E. T2N. etc.). Inverters (3uch as
VF-S7/A5, G3), or Motor protection relays (S2E21).
Transmission system
Half'duplex
Transmission code
ASCII
Transmission speed
300/600/1200/2400/
4800/9600/19200 bps
Framing
bit; 1 bit
Data bits: 7 or B bits
Parity; OdcVeven/nofie
Stop bit; 1 or 2 bits
Message (ength
512 bytes max.
Mete) RS-A^B5 2-wirs sy^sm
Data link mode
Two PLCs (any combination of T2E, T2N or Super
T1-40) can be directly linked together. This direct
link is inexpensive, easily configured and requires no
special programming. File registers FOOOO to F0Q31
are used for the data transfer.
Transmt^ion speed
19200 bps
Protocol
Special
Link data capacity
16 words (station 1 to 2)
16 words (station 2 to 1)
Link data update time
approx. 50 ms
(not synchronized with
T2E/T2NS scan)
T^E orT2N
RS-232C (15 m max.)
RS-485 (1 l«n max.)
T2EorT2N
Station No.1
Station No,2
FO^
FOOOO
FOOIS
F0015
F0016
F0016
F0031
F0031