Flexible serial port, Programmer port, Communication port on the cpu module – Toshiba T2E User Manual
Page 7: Computer link mode
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Flexible Serial Port
Programmer Port
The T2E/T2N’s RS-232C programmer port supports the open T-sprles computer linK protocol as well as the
proprietary programmer protocol. This próvidas an easy connection to a higher level computer, an operator
interface unit, a modem, etc.
Master computer
Operator interface
^
_____ I
.
IlwHiKilKIjEr
T2BT2N
Modem
Telephorre lirve
Modem
Interface
RS-232C
Transmission system
Half-duplex
Transmission speed
36D0 bps
Framing
Start bit: 1 bit
Data bits; B bits
Parity: Odd or none
Stop bit: 1 bit
Protocol
Computer (ink protocol.
Programmer protocol
T2BT2N
Communication Port on the CPU Module
The RS-232C or RS-485 multi-purpose communication port is standard on the T2N CPU. The interface is
selected by a DIP switch.
The RS-232C or RS-4S5 multi-purpose communication port is an option on the T2E CPU. A CM231E or
CMI232E card must be mounted in the T2E CPU module.
By using these communication port, one of the follow'lng three communication modes is available.
Computer link mode
T-sertes computer link protocol can be used in this
mode. When the RS-485 is used, a maximum of 32
T2E/T2NS can be connected to a master computer.
By using this mode, all the T2E/T2N's data can be
accessed by a master computer.
The T-series PLC programming software fT-PDS}
can also he used in this configuration.
Transmission system
Half-duplex
Transmission speed
300/600/1200/2400/
4800/9600/19200 bps
Framing
Stsfl bit: 1 bit
Data bits: 7 or 6 bits
Parity: Odd/ewen/none
Stop bit: 1 or 2 bits
Protocol
Computer link protocol,
Programmer protocof
Master computer
Waster computer
RS-23X {15 rr max.)
T2E/T2N
T2&T2N
T2E/T2N
T2BT2N
32 T2E/T2t4s max.