Toshiba MA-132 SERIES - Manual (Page 43)

2) Depress | AT/TL | to end the percentage rate entry as well as the
entire tax program.
3. °L RATE ONLY
1) Enter "0", depress |TX/M|, and depress |ST|.
2) Enter the percentage rate in the same manner as in 2 - Step 1)
above. Then depress IAT/TL| to end the entire tax program.
NOTES: 1. A maximum of 4 digit value is entered for each break.
2. If any incorrect value is found to have been entered, first
complete the entire tax table program (up to the | AT/TL | key
operation), and do the correct tax table program operation over
again from the frist.
3. In a dual-tax area, program Tax 1 Table first, and then Tax 2
Table. When Tax 1 Table is programmed, Tax 2 Table (if any pre­
programmed) will automatically be reset.
SAMPLE OPERATION: To program the following tax table
(in a single-tax area)
1. FULL^BREAK METHOD
Tax Table
Key Operation
Control Lock: SET,
Clerk 1 Key to ON.
Non-cyclie Breaks
(from) ( to) ( tax) (Enter) (Depres;
Oi \H oi 15 1TX/Ml
16 25 1 25 iTX/Mi
[ H I
Cyclic Breaks
26 45 2 45
rfx/M
1
46 65 3 65 ITX/Ml
66 85 4 85 ¡TX/Ml
86 105 5 105
r'TX/Ml
106 125 6 125 1TX/Ml
1AT/TL!
. COMINATION OF NON-CYCLIC BREAKS AND % RATE
Non-cyclie Breaks
0^ oi 19
i
tx / m 1
20 39 1 39 1 tx / m I
40 59 2 59 | tx 7 m 1
60 79 3 79 ITX/Ml
80 99 4 99
[Jx/MJ
I ST I
5% applied to any amount 500 IAT/TLI
above Non- eye lie Breaks
Thank you
Colt again
0 6 . - 0 4 - 8 4
§ 3 3 3 . 3 3 3
i / 1
0 0 * 0 . 1 5 ^
0 1 * 0 . 2 5 f
* 0 . 2 5 S
0 2 * 0 , 4 5 £
0 ? * 0 . 6 5 ^
0 4 * 0 . 8 5 i
0 5 * 1 0 5 £
0 6 * 1 2 5 i
* 1 2 5 d
I d - 0 0 1 8
1 4 - 0 0
# 1
0 0 * 0 . 1 9 ^
0 1 * 0 . 3 9 i
0 2 * 0 . 5 9 ¡ 5
0 3 * 0 . 7 9 i
0 4 * 0 . 9 9
* 0 . 9 9 %
5 , %
I d - - 0 0 ]. 9
1 4 - - 0 1
- 39 -