Problem solving, Troubleshooting – Crestron electronic CLW-SW1/4RF User Manual
Page 32

infiNET™ Switches
Crestron CLW-SW1/4RF, -SWS1/4RF, -SLVS1RF
Problem Solving
Troubleshooting
The table after this paragraph provides corrective action for possible trouble 
situations. If further assistance is required, please contact a Crestron customer 
service representative. 
infiNET Switch Troubleshooting
TROUBLE
POSSIBLE CAUSE(S)
CORRECTIVE ACTION
Switch is not receiving line 
power. 
Verify that the switch is 
properly connected to the 
power lines and that the 
circuit breaker is closed. 
Load is not connected.
Verify that the load is 
operational and that the mode 
selection switch is in the 
“RUN” or “SET” position. 
Switch does 
not function. 
Mode selection switch is in 
the “SET” position. 
Move mode selection switch 
to the “RUN” position. 
If the LED flashes OFF for ¼ 
second four times, then 
returns to low every eight 
seconds, the switch is not 
acquired on infiNET network. 
Use the Network Device Tree 
infiNET network in Crestron 
Toolbox to poll the infiNET 
network. Acquire the device 
on infiNET network as 
described in “Acquire the 
Switch on the infiNET 
Network” on page 8. 
If the LED flashes OFF for ¼ 
second two times, then 
returns to low, the MNET ID of 
device is not set to match the 
MNET ID of the SIMPL 
Windows program. 
Use the Network Device Tree 
infiNET network in Crestron 
Toolbox to poll the infiNET 
network. Verify that the MNET 
ID for the infiNET device is set 
to match the MNET ID 
specified in the SIMPL 
Windows program. 
Switch does 
not respond 
to control 
system 
commands. 
If the LED flashes OFF for ¼ 
second four times, then 
returns to low every eight 
seconds, the C2N-MNETGW 
is not transmitting data to the 
infiNET device. 
Open Crestron Toolbox and 
select the Network Device 
tree. Expand the network 
device tree until the gateway 
to be managed is selected. 
Right-click the Net ID of the 
selected gateway to open the 
sub-menu and select 
Functions|MNET 
Gateway…. If devices are not 
listed, acquire the device on 
to the infiNET network as 
described in “Acquire the 
Switch on the infiNET 
Network” on page 8. 
(continued on following page)
28
• infiNET Switches: Crestron CLW-SW1/4RF, -SWS1/4RF, -SLVS1RF
Operations Guide - DOC. 6397A
