Changing head cable orientation – Toshiba IK-542XD User Manual

Page 22

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

14. CHANGING HEAD CABLE ORIENTATION

The output direction of the camera cable on the camera head can be changed from left

back (factory setting viewed in front of) to left side. Changing the output direction will

change wiring conditions inside the camera head, so be careful. Changing to right back or

right side is also possible, but consult with the service shop or service personnel in this

case.

(A) Output direction changing from left back to left side

Changing from left

back to left side

Procedures

Description on

procedures

Pull out in left back direction

Pull out in left side direction

1 Æ

ili

^ H 4

1. Remove 2 screws (1 at

back side, 1 at front side)

2. Pull out cable bushing in

side direction (take care

not to damage internal

wiring leads).

3. Insert cable bushing from

back side (take care not

to jam the cable).

4. Tighten the screws firmly.

Note:

Take care not to apply tension and torque to the wiring material inside the camera

head and the flexible PC board, it may cause break down of the wiring leads or dam

age the camera head.