Kenwood BJV140Z - Manual (Page 28)

Recording (DIGITAL input)
Recording is possible using recordable Mini Discs. When this unit is connected with a component equipped with digital output,
such as a CD player, through a digital cord or optical fiber cable, the signal input through the DIGITAL input jack can be recorded
28
in the digital format (this recording is referred to as digital recording). Enjoy high-quality sound of digital recording!
Preparation
O Open the write protect tab of the Mini Disc to make it recordable.
O Load the Mini Disc.
© Check the remaining recording time.
O Set the amplifier's input selector to the source to be recorded.
!
DIGITAL recording
Adjust the settings if required.
O Switch the REC MODE on.
'^CH ARA
© Select the setting adjustment mode.
© Set the selection.
Go TO s;eo □ ¡’ se::ng aa]u5:oieo-;s are no;
r0Q LJ I r 0G
Select one of "DIGITAL 1,2
REC INPUT
Each press switches the mode.
* ' REC MODE ; o"t
— : REC MODE : or, i"AUTO TIME?" a,SD avea
The modes are switched by rotating the JOG DIAL.
1 AUTO TIME?
AUTO LEVEL?
; Setti-'.g tr^e t^nie ’O' aetecrng a no-sconn
Dian*. sec'jon cj’'ng aotoonat c Track r^L.;n'-
oer marking
; SeTTing o' tne icvo to’- oeteclmg a rion-
sDund blank seciiOn aurmg ajToniat c track
n„n^ber marK'ng
REC-^ WRITING? : Settina o' tne UTOC vvntmg a'ter recomi'm'
• For details or the setting 3C|ustme-'t modes., see "REC MODE key"
- 24
Each press switches the mode.
' ANALOG : Analog "stereo -^tooe"
2 DIGITAL 1 : Opt 'cal inout mode
DIGITAL 2 : Coax al inout mode
— t MONO : Analog "monaural lor^g-piay mioae'
Select AUTO or MANUAL
Each press switches the mode.
r*- ’ goes of'(AUTO) : Tracr numbers are marked automatically.
i
'— 2 MANUAL ; Track rrurr-bers can be marked as destred.
- 23