Kenwood KAC 941 - Manual (Page 3)

screws (05 X 50) 4
mmn
on and wiring, remove the terminai of the battery to prevent short-
3ut and output cords of the system,
ound to the metal chassis of the car.
iwer supply lead iyeilow}.
nd after confirming the installation and wirings are correct, connect the
the battery.
trol
jntro! adjasts the input sensitivity
y to 6.0 V continuously, enabling
5 systems. This unit has been set
INPUT
SENSITIVITY
0.3
nit Amplifier input
.) , sensitivity
0.1 V
0.3-0.5 V
Input sensitivity
controller for B Input sensitivity
controller for A
Air outlet
CAUTION
When making the hole,
do not damage the fuel
tank, brake tube, wiring
harnesses, etc. on the
other side.
CUfCiy lUI Scsiwiy UMVMiy.
•Use screws supplied as
accessories when install­
ing the unit,
•Install the unit in a well-
ventilated place and do
not place the (heavy) ob­
ject on it.
• This unit incorporates a
cooler fan, which starts
rotation
automatically
when the temperature
rises during use. Take
care not to block the air
inlet and outlet for this
fan.
2 , installation location
Since the power amplifier has no parts which require operation, it can be installed at a
position away from the driver's seat without any hinderances.
As generally accepted positions for its installation, places such as inside the trunk, etc.
can be considered.
Use the extension cables. CA-5W (0.5 m), CA-15W dm), CA-25W (2 m), CA-45W (4 m),
and CA-65W (6 m) (optional) when the connected models are to be installed away from
the power amplifier.
(En)
5