Char-Broil SANTA FE 10301569 - Manual (Page 9)

3
4
This may require at least two people
.
• Insert a cotter pin through the hole in one end of the axle and bend it so it won’t back out (A).
Axle
Cotter pin
A
Cotter Pin
Axle
9
Slide a wheel onto the axle. Slide axle through hole in bottom of short leg as shown. Slide the
other wheel onto the end of the axle. Insert the remaining cotter pin through the hole in the
axle. Make sure all hardware is tight.
A
Attach (1) short leg and (1) long leg to front of bottom assembly using (3) 1/4-
20x1/2" hex screws from outside and flange nuts from the inside.
Assemble the wood rack to the legs using (4) 1/4-20x ½" hex screws and
flanges nuts as shown in Figure A