Bosch B22CS50SNS - Manual (Page 27)

Fault Possible cause: Remedial action
Ice maker is not making
enough ice or the ice is
deformed.
Low water pressure. Connect appliance to stipulated water
pressure only (see section “Installation
/ Water connection”).
Condensation forms on the
discharge unit of the
dispenser.
The environment is to humide. Switch on the condensation heating.
To switch on the condensation
heating: press the switch to “ON”
(depending on model). To switch off
the condensation heating: press the
switch to “OFF”.
ON OFF
Type A:
Type B: 1...... 0
2.......1
Appliance self­
test
Your appliance features an
automatic self-test program which
shows you sources of faults which
may be repaired by customer
service only.
Starting the appliance
self-test
n Switch off the appliance and
wait 5 minutes.
n Switch on the appliance again.
n Simultaneously press the
“select” and “options” buttons
for 5 seconds.
The self-test starts.
If “E..” is indicated on the display
panel, an error has occurred.
If a fault is indicated, inform
customer service.
Ending the appliance
self-test
n Press the “select” and “options”
buttons again for 5 seconds.
Service
You will need to know your complete
model number (E) and serial number
(FD).
If you need service, first see the
section “Eliminating minor faults
yourself” of this book. After checking
this section, additional help can be
found by calling the Bosch
Customer Interaction Center,
1-800-944-2904 (toll-free),
from anywhere in the U.S.A.
In Canada, contact your designated
Bosch Canada service company or
call 1-800-944-2904.
Write down the following information
about your refrigerator to better help
you obtain assistance or service if
you ever need it.
Dealer name:
Address:
Phone number:
You can find this information on the
rating plate located on the inside wall
of the refrigerator compartment.
Purchase date:
Model number (E):
Serial number (FD):
27