Coleman MEADOW FALLS 2000001390 - Manual (Page 2)

The Coleman Company, Inc. • 3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN CHINA • PRINTED IN CHINA
© 2007 The Coleman Company, Inc.
Coleman ® and are registered trademarks of The Coleman Company, Inc.
STITCH LINE
To Attach Rainfly
continued
To Store
1. All metal poles and stakes must to be placed in the storage
bag to prevent damage to the fabric items placed in the
carry case.
2. Make sure tent is clean and dry before placing in carry case.
3. Remove rainfly, spread out on floor of tent, then unzip
door & vents before taking tent down for storage.
4. Neatly fold tent to width of pole storage bag, place on tent,
roll tightly, and place in carry case.
5. Store in a clean, dry area.
11/07
5. Turn rainfly over and drape over tent
making sure ridge pole is centered
over the door. (Fig. 5)
NOTE: When positioned properly,
seams on rainfly will always align with
poles on tent.
6. Attach hook & loop fasteners,
located on seams of the underside of
rainfly, around the four black main
poles, to secure. (Fig. 5A)
7. Clip hooks on elastic cords, on the
front corners of rainfly, onto metal
loops at front and back corners
of tent. (Fig. 5B)
8. Tie guylines through loops on web
straps on the rainfly. (Fig. 5C)
9. Stretch guylines until taut, then secure
with stakes. (Fig. 5D)
Things You Should Know:
• Under certain conditions (cold weather, high humidity, etc.) condensa-
tion will form on the inside of your tent. Condensation is caused by
water vapor from your breath, perspiration, or any wet clothing inside
the tent. It is NOT LEAKAGE through the tent fabric. It can be minimized
by removing wet clothing from your tent and by providing good ventila-
tion through the tent.
• Never store tent, even for a short period of time, without drying it
thoroughly and brushing off caked dirt. Do not pack stakes or poles
inside your tent. Use a separate storage bag.
• STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF.
NEVER PULL ON THE TENT TO REMOVE STAKE.
• TENT POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER
DURING STORAGE.
• Do not leave your tent set-up for weeks at a time. Be aware that exposure
to ultraviolet rays from the sun can seriously damage material and/or
cause it to become discolored.
WARNING: Keep all flame and heat sources away
from this tent fabric.
This tent meets the flammability requirements of CPAI-84. The
fabric may burn if left in continuous contact with any flame source.
The application of any foreign substance to the tent fabric may
render the flame-resistant properties ineffective.
Electrical Cord Access
1. Unzip access panel in the lower
right corner of tent and bring in
electrical cord. Use only UL approved
cords that are rated for outdoor
usage. (Fig. 8)
Fig. 8
Fig. 5
Cooler Access
The smaller zippered opening at the
rear of the tent is designed for added
ventilation and easy access to your
beverage cooler.
1. To use as a vent, unzip flap to
expose screen. (Fig.6)
2. To use as a cooler access, unzip
other flap to make an avenue to
bring beverages into the tent.
(Fig.7)
Fig. 6
Fig. 7
5D
5A
Black Main
Pole
5B
5C