Cisco 11500 Series - Manual (Page 93)

C H A P T E R
3-1
Cisco 11500 Series Content Services Switch Hardware Installation Guide
78-13884-03
3
Booting and Configuring the CSS
This chapter describes how to boot the CSS and using the configuration scripts.
This chapter contains the following sections:
• Powering Up the CSS
• Powering Down the CSS
• Booting the CSS for the First Time
• Logging in to the CSS
• Using the Configuration Script
For more information on failure errors and messages that can occur during the
boot process, refer to Appendix C,
Troubleshooting .
Powering Up the CSS
To power up a CSS:
• On an AC CSS, toggle the power switch to the 1 (on) position.
– See Figure 2-11 for the location of the CSS 11501 AC power switch.
– See Figure 2-12 for the location of the CSS 11503 AC power switch.
– See Figure 2-14 for the location of the CSS 11506 AC power switch for
each power supply. Power on all of the supplies in the CSS. The AC OK
and DC OK LEDs light up on each power supply. If either LED remains
unlit, refer to Appendix C,
Troubleshooting .