Css 11501 connectors and leds, Figure 2-1 – Cisco 11500 Series User Manual
Page 60
Chapter 2 Cabling the CSS
Cabling the CSS 11501
2-4
Cisco 11500 Series Content Services Switch Hardware Installation Guide
78-13884-03
CSS 11501 Connectors and LEDs
The CSS 11501 has all connectors and LEDs on the chassis front panel.
illustrates the connectors and LEDs on the CSS 11501.
For information on the connector pinouts, refer to Appendix B,
.
Figure 2-1
CSS 11501 Connectors and LEDs
1
Bicolor status LED
(green and red)
6
RJ-45 Ethernet 10BASE-T/100BASE-TX connectors
1 through 8
1
1.
The Ethernet Link/Act LED and Duplex LED are located at the top of each RJ-45 Ethernet connector and are not visible in this
illustration.
2
Amber status LED
7
LC-type SFP GBIC (optional)
3
RJ-45 RS-232 Console connector
8
Link LED for SFP GBIC
4
10-Mbps half-duplex Ethernet
management connector
9
RJ-45 RS-232 Diag connector for field service
diagnostic use only. (A connector cover is provided.
Removing the cover voids the warranty.)
5a
PCMCIA slot 0 containing a flash or
hard disk
10
PCMCIA slot cover
5b
PCMCIA slot 1 (shown empty) for
optional installation of a second flash
or hard disk
11
Recessed button (reserved for field service use only)
CISCO 11500
SERIES
C O N TENT
S E RV ICES S
W I T CH
78930
DUPLEX
LINK/ACT
LINK
STATUS
PCMCIA
GE
CONSOLE
LINK DPLX
LINK DPLX
LINK DPLX
LINK DPLX
1
2
3
4
10/100
LINK DPLX
LINK DPLX
LINK DPLX
LINK DPLX
5
6
7
8
10/100
2
3
4
5b
7
10
11
5a
9
1
8
6