Ii. preparation before threading, Thread tree, Thread spool – Brother 2340CV User Manual
Page 6: Needle position, Ii. threading, Needie threading, Threading the left needle, Threading the center needle, Threading the right needle, Caution
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
II. Preparation before threading
Thread tree
Raise the telescoping thread tree to its highest position.
Make sure that the thread holders are in alignment above
the spool pins as illustrated left.
©Thread holder on thread tree
©Spool pin
©Spool cushion
©Correct position
Thread spool
The procedure for placing the spool of thread on the spool pin differs according to the shape of the spool.
- Type B ---------------------
If you are sewing with loosely
spun nylon thread, we recom
mend that you cover the spool
with the net supplied to prevent
the thread from slipping off the
spool.
Adapt the net to the shape of the
spool.
©Spool support
©Spool cushion
©Net
©Spool support
©Spool mat
©Spool cap
Needle position
(1)Turn off the main power switch for safety.
(
2
)
(2) Set the needle bar in its highest position by turning the
handwheel toward you.
Turn the handwheel to find the easiest position for
threading.
8
II. Threading
Needie threading
3)00
0OO
Pass each thread from (
3
)
0
© to @00 as
shown in this illustration.
Pass the thread through the proper thread
guide.
Slide and hold the thread tension release
button to the right, then pass the thread through
the tension disc which is in the channel next to
the tension adjustment dial. Release the but
ton.
©Tension disk
©Thread tension release button
CAUTION
Always be sure to turn off the power before
carrying out the following operation.
(1) Follow the procedure described below to thread the needle.
Threading the left needle
•
Run the thread in the sequence illustrated, following
the yellow color and the numbers next to each thread
ing point. ((©-©)
Threading the center needle
•
Run the thread in the sequence illustrated, following
the pink color and the numbers next to each threading
point.
(O'©)
Threading the right needle
•
Run the thread in the sequence illustrated, following
the green color and the numbers next to each thread
ing point. (O-©)
CAUTION
When needle threading, always thread in this order:
Left needle, center needle and then right needle.
®To left needle
©To center needle
©To right needle
©Branching plate
©Pull about 6 cm (about 2-1/2 inches) of thread
through the eye of the needle.
®®0 Front to back