Kenmore 116.21513 - Manual (Page 16)

TO DSí'RilPl^/C DCTI T
il
mm I w I \f £*H E wi F I m «« lnNi I
1. Remove light cover
and light bulb as shown
under LiGHT BULB
CHANGING.
2. Unscrew the Power­
Mate* cover screws.
3. Turn
Power-Mate®
over. To
remove cover,
insert
screwdriver at
cover tabs on
both sides
and twist to
release tabs.
4. Turn Power­
Mate® right side
up. Press handle
re
jp^Q£;!a rjpripl
and iower the
swive! Rotate
cover forward
from back until
front snaps free.
5. Carefully
insert and
lift
screwdriver
at each
brush
support to
free brush
from base
6. Remove
worn beit.
Brush
Support
7. Slide brush
supports off to
check and clean
brush support
areas See
BRUSH
ASSEMBLY for
picture of
compietB brush
assembly.
TO RFPi APF RFI T
c 1 MBa» § I mmi mf mm I mh X
1. Slide washers and brush supports onto
brush assembly.
2. install
new belt
over motor
drive, then
over brush
sprocket.
NOTE: See
PARTS AND
FEATURES
for Belt number.
3, Snap brush
supports into
piacB on base.
Be sure brush
supports are
not upside-
down.
Support
4. Line up
front of cover
and base.
Rest cover
on front edge
of base as
shown.
5. Rotate cover
back. Press
cover firmly until
side tabs snap
into piace,
Reptace cover
screws, light
bulb and light
cover,,
16