Light bulb changing, Half light power-wiate, Full light power-mate – Kenmore 116.21513 User Manual
Page 15: Belt ghanging and brush cleaning, Important, Caution, Light bulb changing half light power-wiate
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
LIGHT BULB CHANGING
HALF LIGHT POWER-WIATE®
1
.
Remove Sight
cover by lifting at
arrov/ as shown.
2, Push in and turn
bulb counterclock
wise to remove,
3. Replace the
bulb. Bulb must not
be higher than 15
Watts(130V).
Close light cover
until it snaps in
place
NOTE: See PARTS AND FEATURES for
Bulb number.
FULL LIGHT POWER-MATE®
1, Remove light
cover by pressing
in and lifting both
sides as shown.
2. Push in and turn
bulb counterclock
wise to remove.
3. Replace the
bulb Bulb must not
be higher than 15
Watts (130V).
Close light cover
until it snaps in
place
NOTE: See PARTS AND FEATURES for
Bulb number.
BELT GHANGING AND BRUSH CLEANING
CAUTION
When you remove the end caps, a
small metal washer on each end
may come off. DO NOT lose these
two metal washers.
TO CLEAN AGITATOR:
NOTE: In order to keep cleaning efficiency
high and to prevent damage to your vacuum,
the agitator must be cleaned every time the
belt is changed.
The agitator must aiso be cleaned according
to the following schedule;
Vacuum Use
HEAVY -
(used daily)
MODERATE -
(used 2-3 tlmes/week)
LIGHT -
(used 1 time/week)
Clean Agitator
every week
every month
every 2 months
Remove any dirt or debris in the belt path
area or in the brush roller area.
Carefully remove
any string or
debris located on
the agitator, end
caps, washers or
agitator shaft.
IMPORTANT
Replace the washers and the end caps.
See the exploded view for correct
assembly.
Disconnect cleaner from electrical outlet.
Check and remove hair, string and lint build
up frequently in the Power-Mate® agitator
and end cap areas, II build-up becomes
excessive, disconnect Power-Mate® from
wand and follow the steps below.
15