Kenmore TANNIN 625.348261 - Manual (Page 6)

SECTION 1 WATER FILTER START UP
C. PROGRAM THE TIMER
FIGURE 2
display
UP button
DOWN button
SELECT button
When the transformer is plugged into the electri­
cal outlet a model code is displayed for a few sec­
onds followed by a test number (example: Jl.l).
Then, 12:00 PM and the words PRESENT TIME
will begin to flash in the time display.
Notes:
If---------- shows in the display, press the UP or
DOWN button until "S tAn" shows in the display.
Then, press the SEEECT button to set, and change
to the flashing PRESENT TIME display.
To check the model code, unplug the transformer
at the wall outlet and plug in again,
if other than
this code shows, see page 5-2 to reset.
If the words PRESENT TIME do not show in the
display, press the SELECT button (FIGURE 2) un­
til they do.
SOUND "BEEPER": A "beeper" sounds while
pressing buttons for set-up. One beep signals a
change in the face plate display Repeated beeps
mean the timer will not accept a change from the
button you have pressed, telling you to use anoth­
er button.
1. SET PRESENT TIME OF DAY
Press the UP or DOWN buttons to set the present
time. Press UP to move the display ahead; press
DOWN to move the time backward.
a. If the present time is between noon and mid­
night, be sure PM shows.
U€ 0
l‘JU p"
rofSEIT TIME
b. If the present time is between midnight and
noon, be sure AM shows.
i I* J(L AM
I i-IiO
PBESEii TIME
Each press of the UP or DOWN buttons changes
the time by 1 minute. Holding the buttons in
changes the time 32 minutes each second.
C.
Press the SELECT button once to set the pres­
ent time of day and advance to the next set up
screen.
1-3
Problems, Questions? Call 1-800-426-9345 Kenmore Water Line