A. faceplate timer features, П п п, Лл л – Kenmore TANNIN 625.348261 User Manual

Page 10: Tfiff, How your water filter works

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

SECTION 2

HOW YOUR WATER FILTER WORKS

A. FACEPLATE TIMER FEATURES

The default settings for fill (6:00 minutes), brine
draw (80 minutes), backwash (12 minutes) and
fast rinse (8 minutes) cycles of regeneration are
factory set for maximum performance of the filter.
Use the following procedures to check for correct
cycle times, or to change if desired.

However, only

trained technicians should change the time set
tings.

FILL

Press and hold the SELECT button until the dis
play shows "000- -", then press the SELECT but
ton once to display the Fill time screen.

This setting should stay at the 6:00 minute fill
time.

Using the UP or DOWN buttons, adjust the back
wash time from 0 minutes to 60 minutes.

ADJUSTABLE FAST RINSE

Press and hold the SELECT button until the dis
play shows "000--", then press the SELECT but
ton four times to advance to the Fast Rinse time
adjust screen.

тиШШё

ЛЛ Л _ _

u u u

r П

t t

Tfiff

Using the UP or DOWN buttons, adjust the fast
rinse time from 0 minutes to 60 minutes.

ADJUSTABLE BRINE DRAW

Press and hold the SELECT button until the dis
play shows "000- -", then press the SELECT but
ton twice to advance to the Brine Draw time adjust
screen.

П П П

uuu

Using the UP or DOWN buttons, adjust the brine
draw time from 0 minutes to 255 minutes.

ADJUSTABLE BACKWASH

Press and hold the SELECT button until the dis
play shows "000- -", then press the SELECT but
ton three times to advance to the Backwash time
adjust screen.

Г1Л ri

uuu

. (0

TIMER "POWER-OUTAGE MEMORY"

If electrical power to the timer is interrupted, the
"memory" built into timer circuitry keeps time for
6 hours (minimum) or more. The display is blank
and the filter will not regenerate. When electrical
power comes on, one of two things will happen.

1. The present time of day will show steady,

meaning the timer has not lost time.

2. The display will show a time, but it will be

flashing. The timer memory did not keep the
time setting and must be reset (page 1-3). If
you do not reset the time, regenerations will
most likely be at the wrong time of day.

NOTE:

The flashing display is to remind you to

reset the timer.

NOTE: If the filter was in a recharge when power
was lost, it will now finish the cycle.

2-2

Problems, Questions? Call 1-800-426-9345 Kenmore Water Line