Pioneer PDK-TS01 User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Step 2.
As shown in figure, hook the stand pipe holes (§) onto the screw heads of the installation
bolts ©, then slide the stand upwards to the main plasma display until it engages the
installation bolts ® (once put together with the display, the stand will slides no more
than 19 mm (3/4 inch)).
Step 3.
Pass the installation bolts @ (M8 x 40) through the stand pipes and tighten the installa
tion bolts securely with the included hexagonal wrench (holes should be used in the
proper, (B), (§)■).
Step 4.
Tighten the installation bolts ® securely with the hexagonal wrench provided.
A
Notes
1. Place a sheet or protective cover to protect the (display from scratches or (damage.
2. Assemble only with the plasma display lying flat on a table or similar surface.
3. Do not apply excessive pressure and tighten the bolts more than necessary.
4. Move the stand so that the stand screw holes and the nuts that connect the main display line up correctly.
5. The display weighs approximately 40 kilograms (88 lb.) and has little depth, making the display very unstable.
For this reason, at least two people are required for setup and installation.
12