Kenmore 790.4809 - Manual (Page 8)

Setting the Oven Controls
Setting the Clock
The © pad is used to set the clock. The clock may be set for 12 or 24 hour time of day
operation. The clock has been preset at the factory for the 12 hour operation. When the
range is first plugged in, or when the power supply to the range has been interrupted, the
time in the display will flash (See Fig. 1).
______________________ INSTRUCTIONS_____________________________________ PRESS____
i j - f i n
ICUU
Fig. 1
DISPLAY
To set the clock (example below for 1:30)
1. Press 0 . "CLO" will appear in the display (Fig. 2).
2. Press 13 0 pads to set the time of day to 1:30 (Fig. 3). Press
"CLO" will disappear and the clock will start (Fig. 4).
Changing between 12 or 24 hour time of day display
1. Press and hold ©^ for 7 seconds until "12Hr dAy" or "24Hr dAy
appears in the display.
F!ex ^ ^
2. Press
Clean
to switch between the 12 and 24 hour time of day
display. 12Hr dAy (Fig. 5) or 24Hr dAy (Fig. 6) will be displayed.
Press V_/ to accept the change or press to reject the change.
Reset the correct time as described in To set the Clock above.
Please note that if the 24 hour time of day mode was chosen, the
clock will now display time from 0:00 through 23:59 hours.
©
1 3 0
©
for 7 seconds
Flex
Clean
VSTART/ VSTOP;
I j - n n n n
IC-UU *-*-*-'
Fig. 2
I -Dn n n
I-JU
Fig. 3
lOn
IJU
Fig. 4
H r dfiy
Setting Silent Control Operation
Delay Flex
The
Start
and
Clean
pads control the Silent Control operation feature. The Silent Control
operation feature allows the oven control to be operated without sounds or beeps whenever
necessary. If desired the control can be programmed for silent operation and later returned
to operating with all the normal sounds and beeps.
INSTRUCTIONS PRESS
Fig. 5
ÍW H r M
Fig. 6
DISPLAY
To change control from normal sound operation to silent control
operation
1. To tell if your range is set for normal or silent operation press and
Delay ^
hold
Start
for 7 seconds (Fig. 7).
Flex
2. Press
Clean
to Switch between normal sound operation and silent
operation mode. The display will show either bEEp On (Fig. 8) or
bEEp OFF (Fig. 9).
If bEEp On appears (Fig. 8), the control will operate with normal
sounds and beeps. If bEEp OFF appears (Fig. 9), the control is in
the silent operation mode.
Press to accept the change or press V
—'
to reject the change.
Delay
Start for 7 seconds
Flex
Clean
V start ; \$iopj
Fig. 7
bE fPO"
Fig. 8
bE EP Off
Fig. 9