beautypg.com

General care & cleaning, To replace the oven light bulb, Care and cleaning of stainless steel (some models) – Kenmore 790.9621 User Manual

Page 24: Adjusting the oven temperature, To adjust oven temperature, Adjusting your oven temperature

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

General Care & Cleaning

Changing the Oven Light

Oven

Light

Wire

Holder

The oven light automatically turns ON when the door is opened. The oven light

may also be manually operated by pressing the pad.

The oven light bulb is located at the rear of the oven and is covered with a glass
shield held by a wire holder. The glass shield must be in place whenever the
oven is in use.

To replace the oven light bulb:

1. Turn electrical power off at the main source or unplug the range.

2. Press wire holder to one side to release the glass shield.
3. Replace bulb with a new 40 watt appliance bulb.

4. Replace glass shield over bulb and snap wire holder into place.

5. Turn power back on again at the main source (or plug the range back in),
6. The clock will then need to be reset. To reset, see Setting the Ciock and

Minute Timer in this Use & Care Guide.

CAUTION

Be sure the range is unplugged and all parts are COOL before

replacing oven light. Wear a leather-faced glove for protection against possible
broken glass.

Care and Cleaning of Stainless Steel (some models)

Some models are equipped with stainless steel exterior parts. Special care and cleaning are required for maintaining the
appearance of stainless parts. Refer to the Care & Cleaning Table for detailed cleaning instructions.

Adjusting the Oven Temperature

Your oven control has been precisely set at the factory. This setting may differ from your previous oven however, so your recipe
times may not give you the results you expect. If you think that the oven is cooking too hot or too cool for your recipe times,
you can adjust the control so that the oven cooks hotter or cooler than the temperature displayed.

To Adjust Oven Temperature:

1. Press ^ .

2. Set the temperature to 550°F (287°C) by pressing and holding the .

3. Within 2 seconds, press and hold ^ until the 2 digit display appears. Release

The display now indicates the amount

of degrees offset between the original factory temperature setting and the current temperature setting. If the oven control

has the original factory calibration, the display will read "0."

4. Thetemperaturecannowbeadjustedupordown35°F(17°C),in5°Fstepsbypressingandholdingthe or V . Adjust

until the desired amount of offset appears in the display. When lowering the oven temperature, a minus sign {-) will appear
before the number to indicate that the oven will be cooler by the displayed amount of degrees.

5. When you have made the desired adjustment, press (S) to go back to the time of day display.

Note: Oven temperature adjustments made will not change the Self-Cleaning feature temperature.

24

This manual is related to the following products: