Setting surface controls (contd), Warmer zone, Caution – Kenmore 790.9621 User Manual
Page 10: Setting surface controls -10, Setting surface controls, Orno o o, Contd)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting Surface Controls
(contd)
To Operate Dual Radiant Surface Element (some models)
single setting
Dual Radiant heating areas
on ceramic smooth top (shown In black)
Fig. 1
orno
o o
WARMER ZONE
Warmer Zone Recommended Food
Settings Table
Food Item
Heating
Level
Breads/Pastries
LO
Casseroles
LO
Dinner Plates with Food
LO
Eggs
LO
Gravies
LO
Meats
MED
Sauces
MED
Soups (cream)
MED
Stews
MED
Vegetables
MED
Fried Foods
HI
Hot Beverages
HI
Soups (liquid)
HI
The right front control knob offers flexibilty for different sized cookware with the
Dual Radiant surface element. The inner element alone can be used for smaller
or both the inner and outer in combination for larger cookware.
To operate the Dual Radiant surface element push in the control knob and turn
counterclockwise to operate the small inner coil or turn clockwise to operate
both the innerand outer portions of the element together (See Fig 1).
t
Setting
SINGLE ANDDUALRADIANTSURFACE ELEMENTS
Type of Cooking
HIGH (HI-9)
Start most foods, bring water to a boil, pan broiling
MEDIUM HIGH (7-8)
Continue a rapid boil, fry, deep fat fry
MEDIUM (5-6)
Maintain a slow boil, thicken sauces and gravies or
steam vegetables
MEDIUM LOW (2-4)
Keep foods cooking, poach, stew
LOW (LO - 1)
Keep warm, melt, simmer
Note: The size and type of utensil used, and the amount and type of food being
cooked will influence the setting needed for best cooking results.
Setting the Warmer (Warm & Ready™) Zone (some models)
The purpose of the Warmer Zone is to keep hot cooked foods at serving
temperature. Always start with hot food. It is not recommended to heat cold
food on the WarmerZone.
All food placed on the Warmer Zone should be covered with a lid or aluminum
foil to maintain quality. For best results, when warming pastries or breads, the
cover should have an opening to allow moisture to escape. Do not use plastic
wrap to cover food. Plastic may melt onto the surface and be very
difficult to clean.
Use only dishware, utensils and cookware recommended for oven and cooktop
use on the Warmer Zone.
^CAUTION
Unlike the surface elements, the Warmer Zone will not glow red
when it is hot.
^CAUTION
I Always use potholders or oven mitts when removing food from
the warm zone as cookware and plates will be hot.
Setting the Warmer (Warm & Ready™) Zone Control
1
.
2
.
To set the control, push in either direction and turn the knob (See Fig 2),
The temperatures are approximate, and are designated by HI, MED and
LO. However, the control can be set at any position between HI and LO for
different levels of heating.
When ready to serve, turn the control to OFF, The Warmer Zone will remain
warm until the indicator light goes OFF,
Temperature Selection - Refer to the chart at the side column for
recommended heating levels. If a particular food is not listed, start with the
medium level, and adjust as needed. Most foods can be kept at serving
temperatures by using the medium level.
Note: Use the Warmer Zone to keep cooked foods hot such as; vegetables,
gravies. casseroles, soups, stews, breads, pastries and oven-safe dinner plates.
10