To set the clock, To set the minute timer, To change the minute timer while it is in use – Kenmore 790.9621 User Manual
Page 13: Setting oven controls
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting Oven Controls
: ■ Warm & Eeady Drawer ! '
■ ■
■
Note: The time of day must first be set in order to operate the oven. :
^ ^
^ ^
^ ^
^ ^
'
To Set the Clock
When the range is first plugged in, or when the power supply to the range has been interrupted, the display will flash
"
12
:
00
".
1. Press (O) once (do not hold pad down).
2. Within 5 seconds, press and hold the orN<^ until the correct time of day appears in the display.
Note: The clock cannot be changed during any timed bake or Self-Clean cycle.
To Set the Minute Timer:
1. Press .
2. Press the to increase the time in one minute increments. Press and hold the to increase the time in 10
minute increments. The timer can be set for any amount of time from 1 minute to 11 hours and 59 minutes.
Note: If the N'' pad is pressed first, the timer will advance to 11 hours and 59 minutes.
3. The display shows the timer countdown in minutes until 1 minute remains. Then the display will countdown in seconds,
4. When the set time has run out, the timer will beep 3 times and will continue to beep 3 times every 60 seconds until
is pressed.
Note: The indicator light located above the(S) pad will glow while the minute timer is active.
Note: The minute timer does not start or stop cooking. It serves as an extra timer in the kitchen that will beep when the set
time has run out. The minute timer can be used alone or during any of the other oven functions. When the minute timer is in
use with any other function, the minute timer will be shown in the display. To view other functions, press the pad for that
function.
To Change the Minute Timer while it is in use:
While the timer is active and shows in the display, press and hold the vV or 'V to increase or decrease the time.
Note: Toturn the time of day display OFF or ON in the display press (Oj and hold for 15 seconds (the control will beep
once) and then release. This feature does not remove the set time of day from the memory of the control . When the display
is turned OFF the time of day will re-appear for a few seconds any time the pad is touched.
13