beautypg.com

To replace belt – Kenmore ASPIRADORA 116.23513 User Manual

Page 18

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

TO REPLACE BELT

1. Install new

belt over
motor drive,
then over
brush sprock­
et.

NOTE: See
PARTS AND
FEATURES

for belt number.

2. Place agitator

assembly back into
Power-Mate®.

3. Reinstall
agitator cover
by lining up
the front tabs
and slots and
rotating
downward
until the
latches snap
into place.

4. Line up
front of
cover and
base. Rest
cover on
front edge of
base as
shown.

Base

Top View

5. NOTE: On dirt

sensor models

be sure that the
board is upright
and the wires are

tucked back as

shown.

6. Rotate cover
back. Press cover
firmly until side
and rear tabs snap
into place. Turn

Power-Mate®
upside down and
replace two (2)

cover screws.

1. Remove Power-Mate® cover as shown in
BELT CHANGING AND AGITATOR CLEAN­
ING section.

2. Push in and turn
bulb counterclock­
wise. then pull out
to remove.

3. Push in and turn
bulb clockwise, to

replace. Bulb must
not be higher than
15 Watts(130Volts).

4. Reinstall Power-Mate cover as shown in

BELT CHANGING AND AGITATOR CLEAN­
ING section.

NOTE: See PARTS AND FEATURES for

bulb number.

18

This manual is related to the following products: