Warning, Fire and/or electrical shock hazard, Exhaust filter hepa – Kenmore ASPIRADORA 116.23513 User Manual
Page 16: Electrical shock or personal injury hazard, Exhaust filter changing, Exhaust filter
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
A
WARNING
Fire and/or Electrical Shock Hazard
Do not operate with a clogged
exhaust filter or without the exhaust
filter or exhaust filter cover installed.
EXHAUST FILTER
HEPA
The exhaust filter cartridge must be
replaced when dirty. Replace the filter when
the entire surface area is covered evenly.
The filter CANNOT be washed as it will
lose its dust trapping ability.
NOTE:
See PARTS AND FEATURES for
exhaust filter number.
1. Pull up on
the exhaust fil
ter cover to
remove from
the motor cover
and lay aside.
Exhaust
A
Fitter
i
Cover.^
Exhaust
Filter
2. Slightly push
the exhaust filter
cartridge to the
side, as shown in
the illustration,
and pul! up to
remove.
3. Replace the
exhaust filter car
tridge, carefully
positioning it so
that the side
shown in the
illustration goes
down under the
ribs. Then push
the other side
down until it snaps into place. Place the new
filter into the motor cover with the
grey
edge down.
Exhaust
Filter-
Exhaust
Filter Cover-
Tabs
4. Replace the
exhaust filter
cover by engag
ing the two tabs
on the rear and
pushing down in
front until it
snaps closed.
Always follow all safety precautions when
cleaning and servicing the Power-Mate®.
5^
A
WARNING
Electrical Shock Or Personal Injury
Hazard
Disconnect electrical supply before
servicing or cleaning the unit.
Failure to do so could result in elec
trical shock or personal injury from
cleaner suddenly starting.
16