beautypg.com

Electrical, Electrical connections, Solar installation – Kenmore ELITE 153.33264 User Manual

Page 24: Wiring diagram, Awarning, Jllj

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

ELECTRICAL

Electrical Connections

Before plugging in the water heater, always make sure:

The Voltage and frequency correspond to that specified on

the water heater.

The electrical outlet has the proper overload fuse or breaker

protection.

Unit is to connect to a 120VAC electrical supply outlet

(extension cord is not allowed).

AWARNING

Electric Shock Hazard

^Jllj

Disconnect power before

servicing.

Replace all parts and panels
before operating.

Failure to do so can result in

death or electrical shock.

IMPORTANT: Do not use an extension cord to connect the water

heater to an electrical outlet.

The water heater and the outlet are properly grounded.

Installed in accordance with prevailing provisions of

local codes, or in the absence of such. National Electric
Code, ANSI/NFPS 70 current edition.

Completely fill the tank with water and check all connections for
leaks. Cpen the nearest hot water faucet and let it run for three (3)
minutes to purge the water lines of air and sediment and to ensure
complete filling of the tank. The electrical power may then be
turned on. Verify proper operation after servicing.

Solar Installation

If this water heater is used as a solar storage heater or as a

backup for the solar system, the water supply temperatures to
the water heater tank may be in excess of 120°F. A mixing valve
or other temperature limiting valve must be installed in the water
supply line to limit the supply temperature to 120°F.

NCTE: Solar water heating systems can often supply water with

temperatures exceeding 180°F and may result in water heater

malfunction.

Wiring Diagram

FIGURE 27.

Air Intake
Chamber Fan

Gas Control
Valve / Thermostat

Pressure
Switch

Igniter/Flame

Sense Connector

3

/ / Control Display

Anode

Rod

CAUTION:

DO NOT USE AN EXTENSION
CORD TO CONNECT THE
TRANSFORMER TO AN
ELECTRICAL OUTLET.

'TV,.

FV

Sensor

CAUTION:

LABEL ALL WIRES PRIOR TO

' I

DISCONNECTION WHEN SERVICING

I

CONTROLS. WIRING ERRORS CAN CAUSE

t

IMPROPER AND DANGEROUS OPERATION.

VERIFY PROPER OPERATION AFTER SERVICING.

Iff

Power Supply

Transformer

24

This manual is related to the following products: