Kenmore 64182 - Manual (Page 5)

ROUGH-IN DIMENSIONS
UNPACKING
1. Using the four shipping carton corner posts (two on each
side), carefully lay the dryer on its left side and rennove foann
shipping base.
 CAUTION I
To prevent dannage, do not use the control panel
or coin nneter housing as a nneans to pick up or nnove the dryer.
Your dryer is designed so the door swing nnay be reversed at any
tinne without additional parts. Conversion is accomplished by
transferring hinges to the opposite side of the cabinet.
To change the direction of the door opening:
47 1/2"
(120.7 cm)
DOOR OPEN 90'
SIDE VIEW
4 3/8"
Cl 1.1 cm)
OPTIONAL
VENT KNOCKOUT
27‘
( 68.6 cm)
(Figure 1)
y 3/4"
(9.5 cm)
1. Open the dryer door. Remove the four hinge hole plugs from
the left side of the door opening. Place nearby for future
installation.
NOTE. You may need a plastic knife to help pull out the plugs.
Be careful not to scratch the paint.
2. Remove the four screws that secure the door hinges to the
dryer front panel (see below). NOTE: Remove one screw from
each of the two hinges first. Hold the door firmly before
removing the last two screws.
3. Rotate the door 180° and reinstall the door hinges to the dryer
front panel with the four screws.
4. Install the four
hinge hole plugs
in the open
screw holes on
the right side of
the door
opening.
REMOVE 4 SCREWS
(ONE EROM EACH
HINGE FIRST)