Kenmore 64182 - Manual (Page 2)

Contents Product Record
SUBJECT PAGE
Pre-Installation Requirements...................................... 2 For Sears warranty information or to contact a Sears Service
Electrical Requirements................................................ 3 Center, call 1-800-4-my-HOME (1-800-469-4663)
Exhaust System Requirements.................................3-4 ¡f
„eed
SERVICE or PARTS for your Kenmore
Gas Supply Requirements............................................. 4 coin-operated washer: be ready to give the model
Unpacking 5 number, serial number and date of purchase. Record
Reversing Door Swing...................................................5 below.
Location of Your Dryer.............................................. 6
Electrical Installation.....................................................7
Model number -------------------------------------
Grounding Requirements.......................................... 7
Electrical Connections—3-wire................................... 8
Serial number __________________________________________________
Electrical Connections—4-wire................................. 8
Installation....................................................................9
Purchase date ___________________________________________
Lint Blade Retaining Pin Location.............................. 9
Meter case instructions...........................................9-12
Record Coin Box
Key Number__________________________________
Warranty..................................................................... 15 Key number is on key and/or coin box.
Back Cover.............................................................. 16
DRYER SAFETY
Before beginning installation, carefully read these instructions. This will simplify the installation and ensure the dryer
is installed correctly and safely. Leave these instructions near the Dryer after installation for future reference.
NOTE: The electrical service to the Dryer must conform with local codes and ordinances and the latest edition of the
National Electrical Code, ANSI/NFPA 70.
NOTE: The gas service to the Dryer must conform with local codes and ordinances and the latest edition of the
National Fuel Gas Code ANSI Z223.1.
Your safety and the safety of others is very important. We have provided many important safety messages in the Installation
Instructions / Use & Care Guide and on your appliance. Always read and obey all safety messages.
IThis is the safety alert symbol. This symbol alerts you to hazards that can kill or hurt you or others. All safety messages will
be preceded by the safety alert symbol and the word "DANGER" or "WARNING". These words mean:
A danger
A WARNING
You can be killed or seriously injured if you don't immediately follow instructions.
You can, be killed or seriously injured if you don't follow instructions.
All safety messages will identify the hazard, tell you how to reduce the chance of injury, and tell you what can happen if the
instructions are not followed.
A WARNING
I For your safety the information in this manual must be followed to minimize the risk of fire or explosion or to prevent
property damage, personal injury or loss of life.
- Do not store or use gasoline or other flammable vapors and liquid in the vicinity of this or any other appliance.
- WHAT TO DO IF YOU SMELL GAS
■ Do not try to light any appliance.
■ Do not touch any electrical switch; do not use any phone in your building.
■ Clear the room, building or area of all occupants.
■ Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
■ If you cannot reach your gas supplier, call the fire department.
Installations must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by the state,
province, or region where this appliance is being installed.
PRE-INSTALLATION REQUIREMENTS
Tools and Materials Required for Installation:
1. Phillips head screwdriver.
2. Channel-lock adjustable pliers.
3. Carpenter's level.
4. Flat or straight blade screwdriver.
5. Duct tape.
6. Rigid or flexible metal 4 inch (10.2 cm) duct.
7. Vent hood.
8. Pipe thread sealer (Gas).
9. Plastic knife.
2