beautypg.com

Kenmore 64182 User Manual

Page 12

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

To remove block-out keys, pull straight up.

NOTE:

Be sure block-out keys and /or dime inserts are seated

properly and ratchet dog is in place with irs spring connected
(see FIGURE 8).

Be sure the proper coin sizing block is in place.

Ratchet

Dog and

pring

Block-Out

Keys

FIGURES

Change coin sizing

block:

Remove two screws that hold upper coin chute cover.

Remove cover (see FIGURE 9).

(2)

Upper Coin

Chute

Cover

Screws

FIGURED

Anti-Cheat

Gate

(2)

Coin Sizing

Block Screws

STEP?
Replace coin receiver block into slide:

Flold coin receiver right side up in the palm of one hand.

• Lower coin slide until coin receiver block fits into the coin

slide cavity. CAUTION: Do not dislodge ratchet dog and

spring.

• Flold coin receiver block in place with your fingers and turn

slide upside down.

• Insert and tighten screw.

STEPS

Install slide into coin chute. Slide can only be pushed in if the
anti-cheat gate in flange is pushed to the left, (see FIGURE 9).

STEP 9

Replace coin slide stop with two screws. Replace coin slide
return spring. Replace coin slide extension with two screws (be

sure spacers are in place).

STEP 10

Replace coin slide mechanism in meter case. Replace and tighten

coin slide mounting bolt.

NOTE:

It may be easier to insert coin slide mounting bolt if you

remove the timer from the mounting screws temporarily.

REPLACEMENT PARTS

If replacement parts are needed for your dryer, contact the source

where you purchased your dryer, or call Sears Parts and Service
Toll Eree Number 1-800-4-MY-HOME (1 -800-469-4663). Eor coin

box parts, call 1 -800-221-0982, Greenwald Industries.

À CAUTION

Label all wires prior to disconnection when

servicing controls. Wiring errors can cause improper and
dangerous operation. Verify proper operation after servicing.

Remove two screws that hold coin sizing block to upper coin

chute cover cover (see EIGURE 10).

Put new coin sizing block in place. Reinsert and tighten
mounting screws.

Replace coin chute cover. Reinsert and tighten screws.

WARNING

Destroy the carton and plastic bags after the

dryer is unpacked. Children might use them for play. Cartons
covered with rugs, bedspreads, or plastic sheets can become
airtight chambers causing suffocation. Place all materials in a
garbage container or make materials inaccessible to children.

WARNING

The instructions in this manual and all other

literature included with this dryer are not meant to cover every
possible condition and situation that may occur. Good safe
practice and caution MUST be applied when installing, operating
and maintaining any appliance.

12

This manual is related to the following products: