To slide the shelf from side to side, To remove the shelf, To remove the shelf track – Kenmore 2200128 User Manual
Page 17: To replace the shelf, To remove the drawer, To remove the cover, Pn some mocielsi
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
pn some mocielsi
To slide the shelf from side to side:
1. Lift up on the front of shelf and slide to the desired
location.
2.
Lower shelf to the level position.
NOTE:
You do not have to remove small items from the
shelf before moving it from side to side. You may need to
remove larger items.
To remove the shelf:
NOTE:
The shelf is heavy and must be removed using both
hands.
1. Remove all items from the shelf.
2.
Hold the back of the shelf with one hand.
3.
Lift the front of the shelf with the other hand to a 45°
angle and lower it slightly to release it from the upper
channel of the track.
4.
Pull the shelf straight out.
To remove the shelf track:
1. Lift both sides of the track slightly.
2.
Pull straight out.
To replace the shelf track:
1. Guide the track hooks into the shelf support slots on the
back wall.
NOTE:
Make sure that both sets of track hooks are in
the slots and that the slots are parallel with each other.
2.
Push the track back and down securely into the shelf
supports.
To replace the shelf:
NOTE:
Make sure that both of the rear shelf slides are
securely in the track before letting go of the shelf. The
lateral shelf may be difficult to install if the track is placed
too close to the refrigerator ceiling. Reposition the track on
a lower rung until the shelf can be tilted enough to easily
slide into the track.
1. Hold the shelf at the front and tip the front at a 45° angle
to the track.
2.
Insert both of the rear shelf slides into the upper
channel of the track.
3.
Lower the front into place.
To remove the drawer:
1. Slide the drawer straight out to the stop.
2.
Lift the front slightly and slide it out the rest of the way.
3.
Replace the drawer by sliding it past the drawer stop.
To remove the cover:
1.
Remove the drawer and the crisper.
2.
Lift the front of the cover off of the supports and remove
it by pulling up and out.
To replace the cover:
1. Fit the back of the cover into the notch supports on the
walls of the refrigerator and lower it into place.
2.
Replace the drawer and crisper.
17