The water filter status light, Changing a water filter cartridge – Kenmore 2200128 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

3.
Take the new cartridge out of its packaging and remove
protective cover from o-rings.
The water filter status light
The water fiiter status iight will help you know when to
change your water filter cartridge. The iight is iocated at
the top of the refrigerator compartment. The iight wiil
change from green to yeiiow. This telis you that it is almost
time to change the water filter cartridge (90% of the fiiter
life has been used). It is recommended that you replace
the water filter cartridge when the water filter status light
changes to red OR water fiow to your water dispenser or
ice maker decreases noticeably. (See “Changing a water
fiiter cartridge" iater in this section.)
NOTE: Do not use with water that is microbiologically
unsafe or of unknown quality without adequate
disinfection before or aher the system.
4. Siide the cartridge cap onto the new cartridge as
shown.
WATER FILTER STATUS
GREEN
'FILTER IS OK
YELLOW
• LOW FILTER LIFE
RED
'REPLACE FILTER
RESET WATER FILTER STATUS
PRESS LIGHT SWITCH (5) TIMES
After changing the water fiiter cartridge, reset the water
fiiter status light by pressing the iight switch 5 times within
10 seconds. The status light wili change from red to green
when the system is reset.
Changing a water filter cartridge
The water fiiter is located below the freezer compartment
door.
1. Locate the water filter cartridge cap in the front base
grille below the freezer compartment door. Rotate the
cap counterclockwise to a verticai position and pull the
cap and filter cartridge out through the base griiie.
NOTE:
There wili be water in the cartridge. Some
spilling may occur.
5.
With cartridge cap in the verticai position, push the new
filter cartridge into the base griiie until it stops. Rotate
the cartridge cap ciockwise to a horizontal position.
6. RUN WATER THROUGH THE DISPENSER UNTIL THE
WATER RUNS CLEAR (about 2 to 3 gallons or 6 to 7
minutes). This will clean the system and clear air from
the lines. Additional flushing may be required in some
households.
NOTE:
As air is cleared from the system, water may
spurt out of the dispenser.
2.
Remove the cartridge cap by sliding it off the end of the
old cartridge. The cap will slide to the left or right. DO
NOT DISCARD THE CAP.
15