Materials and basic tools needed, Materials needed, Basic tools – Kenmore POWER MISER 153.32676 User Manual
Page 5: Materials needed basic tools, When sweat soldering
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Materials and Basic Tools Needed
Materials Needed
To simplify the installation Sears has available the installation
parts shown below. You may or may not need ail of these materi
als, depending on your type of installation.
!»
«
■Í i ■.!
Ip ^
i i k i
WATER HEATER INSTALLA
TION KIT WITH FLEXIBLE
CONNECTORS FOR 3/4" OR
1/2" THREADED OR COPPER
PLUMBING
EXPANSION TANKS FOR THERMAL
EXPANSION CONDITIONS AVAILABLE
IN 2 GALLON AND S GALLON CAPACITY
THROUGH LOCAL SEARS STORE OR
SERVICE CENTER
DRAIN PANS AVAILABLE IN 20"
DIAMETER FOR WATER HEATERS
HAVING A DIAMETER IS" OR LESS.
24" DIAMETER FOR WATER
HEATERS HAVING A DIAMETER 22"
OR LESS AND AVAILABLE IN 28"
DIAMETER FOR WATER HEATERS
HAVING A DIAMETER 26" OR LESS
Basic Tools
You may or may not need all of these tools, depending on your
type of installation. These tools can be purchased at your local
Sears store.
Pipe Wrench (2)
Screwdriver
6
Foot Tape or Folding Rule
Garden Hose
Drill
Pipe Dope or Teflon Tape
6 FOOT TAPE
GARDEN HOSE
SLOT-HEAD SCREW DRIVER
PIPE
WRENCH
PHILLIPS SCREWDRIVER
li____ -
PIPE DOPE
(SQUEEZE TUBE)
ROLL OF TEFLON TAPE DRILL
(Use only on water connections)
WHEN SWEAT SOLDERING
Tubing Cutters or Hacksaw
Propane Torch
Soft Solder
Solder Flux
Emery Cloth
Wire Brushes
HACKSAW
3/4" WIRE BRUSH
1/2" WIRE BRUSH
Ò
ROLL OF LEAD FREE
SOFT SOLDER
ROLL OF EMERY
CLOTH
SOLDER
FLUX
L
PROPANE TORCH
TUBING
CUTTER