Kenmore POWER MISER 153.32676 - Manual (Page 18)

Service and Adjustment (cont’d)
Element Cleaning/
Replacement
NOTE; These instructions are written for element cleaning
and element replacement for the lower element. If it is neces­
sary to clean or replace the upper element, then repeat these
instructions.
To remove the element from your tank in order to clean or
replace it;
1. Before beginning turn “OFF” the electric power supply to the
water heater.
A WARNING
HAZARD OF ELECTRICAL SHOCK! Before removing
any access panels or servicing the water heater, make
sure the electrical supply to the water heater is turned
“OFF”. Failure to do this could result in DEATH, SERI­
OUS BODILY INJURY, OR PROPERTY DAMAGE.
2. I'urn off the water supply to the water heater at the water
shutoff valve or water meter.
3. Attach a hose to the water heater drain valve and put the
other end in a floor drain or outdoors. Open the water heater
drain valve. Open a nearby hot water faucet which will relieve
pressure in the water heater and speed draining.
A WARNING
The water passing out of the drain valve may be
extremely hot. To avoid being scalded, make sure all con­
nections are tight and that the water flow is directed
away from any person.
4. Remove the two screws securing the access panel, and remove
panel.
5. Remove the insulation block and pad.
6. Lift out the tab as shown to unclip the terminal cover from
the thermostat. The terminal cover can now be removed
from the thermostat.
18