Kenmore POWER MISER 153.32676 - Manual (Page 15)

Installation Instructions (cont’d)
Installation Checklist
whether or not the element conversion is made, the model
rating plate must be marked. Using a hard point ink pen,
check the appropriate block within the model rating plate,
which is located adjacent to the lower access panel.
Is the fuse or circuit breaker size correct as shown in the chart
in the “Product Specifications” section?
Are the wires from the circuit breaker or fuse service to the
water heater's junction hox on the correct wire size (gauge) as
shown in the chart in the “Product Specifications” section?
Is the new temperature-pressure relief valve properly installed,
and piped to an adequate drain? See “Temperature-Pressure
Relief Valve” section.
Is the water heater completely filled with water? See “Filling
the
Water Heater” instructions in the “Installation
Instructions” section.
Will a water leak damage anything? See “Facts to Consider
About the Location” section.
Are the cold and hot water lines connected to the water heater
correctly? See “Water Piping” instructions in the “Installation
Instructions” section.
Is there adequate clearance for maintenance around the water
heater?
Do you need to call your electric company to check your
wiring?
HOT
OAfONS BW №tTEn M.-
wm> uranoN hooel i WnatAI MiVR
MODEL WaffiER
ELECmfC WàTER HEATER
BBBALHiaiBER
FACTORY È
UPPER LOWER
m L
.S.GAL.
MUOilUif KYWOSTATC
150
WATI^ WATT8 WATt?
AC-OW.V if B48T*iiED AS P.S.I, DPnONALWATTABE
FACTORY SOWPPED
nSym MAXIMUM
CHECK ff’VISRE
CCWVERSION
INS1TÌUC1ÌON
WATTS WATTS WATTO IFCOWffiRTH)
MODEL RATING PLATE
15