Kenmore ASPIRADORA 116.36722 - Manual (Page 15)

DUST BIN FILTER CHANGING / CLEANING
Check primary filter frequently and clean
when dirty. Remove the dust bin assembly
as outlined in the DUST BIN CLEANING
section and empty contents of dust bin.
Make sure dust bin is empty before filter is
removed. Grasp fitter screen, rotate
counter-clockwise and lift out.
Grasp primary filter, rotate counter­
clockwise and lift out. Clean primary filter
by gently tapping over a trash container.
The filter may be cleaned by tapping it on a
firm surface. Tap on several sides to
ensure best cleaning.
Every 6 months rinse filter exterior with
water under a faucet. Once the filter is
rinsed clean, dry with a cloth and let air dry
for 24 hours.
Rinse with water only, do not use detergent
or soap. Allow filter to dry 24 hours
before putting it back into the dust bin.
When the cleaning of the filter no longer
restores vacuum cleaner suction to full
power you need to replace the filter.
Before replacing the primary filter it is a good
idea to clean the inside of the dust bin and lid
area.
tabs in lid.
To re-install the filter screen, align tabs on
filter screen with tabs on lid.
place.
PRIMARY FILTER REPLACEMENT
Primary
Filter
Before replacing the filter it is a good idea to
dean the inside of the dust bin and lid area.
Rotate filter clockwise until slots lock onto
tabs in lid.
NOTE: Under normal use and care, your fil­
ter can be expected to last up to 3 years.
NOTE: See Parts and Features for Filter
number.
15