To clean agitator, Important, Clean agitator – Kenmore 11 User Manual
Page 17: To replace belt
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TO CLEAN AGITATOR;
NOTE; tn order to keep cleaning efficiency
high and to prevent damage to your vacu
um, the agitator must be cieaned every time
the belt is changed.
The agitator must also be cleaned accord
ing to the following schedule:
Vacuum Use
HEAVY -
(used daily)
MODERATE -
(used 2-3 times/week)
LIGHT -
(used 1 time/week)
IMPORTANT
Clean Agitator
every week
every month
every 2 months
Disconnect cleaner from electrical outlet.
Check and remove hair, string and lint build
up frequently in the Power-Mate® agitator
and end cap areas.
Remove any dirt or debris in the belt path
area or in the brush roller area.
Carefully remove any string or debris
located on the agitator, or end caps.
TO REPLACE BELT
1. Install new
belt over
motor drive,
then over
brush
sprocket.
NOTE: See
PARTS AND
FEATURES
for belt number.
Agitator End Cap
Motor
Drive
Brush
Sprocket
Cover
Base
2. Place agitator]
assembly back
into Power
Mate®.
3. Line up
front of
cover and
base. Rest
cover on
front edge of
base as
shown.
4. Rotate cover
back. Press
cover firmly until
side and rear
tabs snap into
place.
Make sure there
is no gap
between the cover and base.
Rear
Latches
5. Turn Power-Mate® upside down and
replace two (2) cover screws.
17