Kenmore 1T6.29429 User Manual

Page 15

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

5. Carefully
insert and

twist
screwdriver

at each
brush

support to

free brush
from base.

Brush

Support

6. Remove worn
bait,

7. Slide brush
supports off to
check and dean

brush support
areas. See
BRUSH

ASSEMBLY for
picture of
complete brush
assembly.

TO REPLACE BELT:

1. Slide washers and brush supports onto
brush assembly,

2. Install
new belt

over motor

drive, then

over brush
sprocket.

NOTE: See
PARTS AND
FEATURES

for Belt #.

Motor

J5=4)\

Brush

Sprocket

Support

3. Snap brush

supports into
place on base.

Be sure brush

supports are

not upside-
down.

4. Line up
front of cover

and base.
Rest cover

on front edge

of base as
shown.

5. Tilt cover to
back. Press
cover firmly until

side tabs snap
into place.

Replace cover

screws, light

bulb and light
cover.