Power-iviate^« care, Warning, Light bulb changing – Kenmore 1T6.29429 User Manual

Page 14: Belt changing and brush cleaning, Power-mate™ care

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

POWER-IVIATE^« CARE

Always follow ail safety precautions when

cleaning and servicing the POWER-MATE'^

WARNING

Electrical Shock Or Personal Injury

Hazard

Disconnect electrical supply before

servicing or cleaning the unit
Failure to do so could result in elec

trical shock or persona! injury from

cleaner suddenly starting.

LIGHT BULB CHANGING

1. Remove light

cover by pressing
in and lifting both

sides as shown*

Push !n

And Turn

Push in and turn

bulb counterclock

wise to remove.

3. Replace the bulb.
Bulb must not be
higher than 15 Watts,

Close light cover until
it snaps in place.

NOTE: See PARTS AND FEATURES for
Buib #

BELT CHANGING AND BRUSH CLEANING

Disconnect cleaner from electrical outlet

Check

and remove hair, string and lint build

up frequently in the POWER-MATE™ brush
and brush support areas. If build-up
becomes excessive, disconnect POWER
MATE™ from wand and follow the steps

below. Instructions can also be found under
the light cover.

I mCw-IVlVi^V C"

j f

1. Remove light

cover and light

bulb as shown
under LIGHT
BULB
CHANGING.

2. Unscrew the

POWER
MATE™ cover

i , — ¡ A - --------- screws.

3. Turn
POWER
MATE™ over.

To remove

cover, insert
screwdriver at
cover tabs on

both sides and
twist to
release tabs

Quick

Release

4. Turn POWER
MATE™ right
side up. Press
handle release
pedal and lower

the swivel, Tilt

cover forward

from back until
front snaps free.