beautypg.com

Motor safety filter cleaning, Warning, Cleaning exterior and attachments – Kenmore 1T6.29429 User Manual

Page 13: Caution

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

MOTOR SAFETY FILTER CLEANING

There are two motor safety filters: 1, a dark foam filter incorporated in the red frame and
2. a white electrostatic filter that is laid on the back side of the dark foam filter
These filters should be checked with each bag change. The dark foam filter can be washed,
per the instructions below and the white filter must be replaced when dirty

3. Peel the white

filter off the dark
foam filter as

shown,. Lay a new

white filter on the
dark filter by align­
ing the notches In
the filter with the
legs of the frame.

WARNING

Electrical Shock Hazard

Do not operate the cleaner without

the motor safety filter. Be sure the
filter is dry and properly installed to

prevent motor failure and/or
electrical shock.

1. Unplug cord

from wait outlet

and remove
bag,

2. Pull out safe­

ty filters as

shown,

dark

foam

filter

This filter and the frame can be washed in
warm soapy water, rinsed and air dried.

DO

NOT clean in a dishwasher or clothes
washer or install while damp.

WHITF FI

pctros

TATIC FII TFR

m W W

i I I MM MM M

m

I

mmi

mm

i I « S

um

mt

I I it M

m

I t K

hm

I Law I \

This filter must be replaced when dirty, it
should be replaced regularly depending on
use conditions.

The filter CANNOT be

washed as it will lose its dust trapping
ability.

White

Etectrostaiic
Filter

Dark Foam
Filter

The new filter can be purchased under

part number 4369971 at your local Sears
Service Unit, 20-86886 at most Sears
Retail stores, or ordered by calling the

Toll Free Number 1-800-366-7278 for

English speaking operator or 1-800-659­
7084 for Spanish speaking operator.

4. Snap filter

back Into canis­

ter,

5. Insert bag.

CLEANING EXTERIOR AND ATTACHMENTS

1. Unplug cord from wall outlet. DO NOT
drip water on cleaner.

2. Ciean exterior using a clean, soft cloth
that has been dipped in a solution of mild
liquid detergent and water, then wrung dry.
Wipe dry after cleaning,

3. To reduce static electricity and dust build­
up, wipe outer surface of cleaner and
attachments.

DO NOT USE ATTACHMENTS iFTHEY ARE

W |!il: I

A

CAUTION

Attachments used in dirty areas,

such as under a refrigerator, should
not be used on other surfaces until

they are washed. They could leave

marks.

13