beautypg.com

Storage drawer, Removing and replacing storage drawer, Changing oven light – Kenmore 790.4626 User Manual

Page 19: General care & cleaning (confcl)

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Storage Drawer

Use the storage drawer for storing cooking utensils. The drawer can de removed

to facilitate cleaning under the range. Use care when handling the drawer.

Removing and Replacing Storage Drawer

To remove the drawer:

1. Pull empty drawer out to the roller guide stop.

2. Tilt the drawer up and pull it out over the rollers.

To replace the drawer:

1. Insert the rear end of the drawer into the opening.

2. Fit the drawer end rollers onto the guide rails.
3. Push the drawer in until it stops, then lift to allow the rollers to clear the

roller guide stop, and push in.

General Care & Cleaning (confcl)

Changing Oven Light

£!3SiSiUiSl£l Be sure the oven is unplugged and all parts are COOL before replacing the oven light bulb. Do not turn the
oven light on during a self-cleaning cycle. High temperature will reduce lamp life.

On some models an interior oven light will turn on automatically when the oven is opened.

The oven light may be turned on when the door is closed by using the oven light switch located on the Electronic Oven
control.

The oven light bulb is covered with a glass shield held in place by a wire holder. THIS GLASS SHIELD MUST ALWAYS

BE IN PLACE WHEN THE OVEN IS IN USE.

To Replace the Light Bulb:

BE SURE OVEN IS COOL

ik CAUTION

1. Turn the power off at the main source.

2. Wear a leather-faced glove for protection against possible broken glass.
3. Replace bulb with a 40 Watt appliance bulb only.
4. Press wire holder to one side to release glass shield, change bulb and

be sure to replace glass shield.

rri

Si

p"

ci

'X

19