To replace belt, Light bulb changing – Kenmore 116.23812300 User Manual

Page 17

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

TO REPLACE BELT

1. Install new

belt over motor
drive, then
over brush
sprocket.

NOTE: See
PARTS AND
FEATURES

for belt num

ber.

2. Place agitator
assembly back
into Power-Mate®

. Rotate

cover back.
Press cover

firmly until side

and rear tabs
snap into
place. Turn
Power-Mate®

upside down

and replace
two (2) cover screws.

3. Line up
front of
cover and

base. Rest

cover on

front edge

of base as
shown.

LIGHT BULB CHANGING

1. Remove Power-Mate cover as shown in
BELT CHANGING AND AGITATOR CLEAN
ING section.

2, Push in and turn

bulb counterclock

wise, then pull out
to remove.

3. Push in and turn
bulb clockwise, to
replace. Bulb must
not be higher than

15 Watts(130 Volts).

. Reinstall Power-Mate cover as shown in

BELT CHANGING AND AGITATOR CLEAN
ING section.

NOTE: See PARTS AND FEATURES for
bulb number.

This manual is related to the following products: