Kenmore 116.23812300 - Manual (Page 7)

CANISTER
1. open the canister hood.
2. Check to see that the dust bag is proper­
ly installed. See BAG CHANGING for
instructions.
3. Check to see that the motor safety filter is
properly installed. See MOTOR SAFETY
FILTER CLEANING for instructions.
HOOD AND TOOL
STORAGE COVER
It is normal for the canister hood and tool
storage cover to come off when opened fur­
ther than needed. Line up the hinge slots,
insert the hinges into the slots, and close
the hood and tool storage cover to reinstall.
A
CAUTION
Never open canister hood with the
tool storage cover open. This will
help to prevent damage from
occurring to the canister hood
and/or toot storage cover.
HOSE
1. Line up the
hose latch tab and
notch in canister
hood and insert
hose into canister
until it snaps in
place.
To remove: Lift
hose latch tab
upward and pull up
on hose.
Hose
Latch
Tab
Notch
2. Insert han­
dle into wand
until lock but­
ton snaps in
place. Be
sure hose is
not twisted.
To remove:
Press handle
quick release
button and
pull up on
handle.
To store: Disconnect hose from wands and
canister to prevent stress on hose during
storage. Store hose in a loosely coiled
position so the hose covering is not
stressed.
Wi
.............................. -MATE JR « STORAGE
This canister is equipped with an on-board
storage area for a Power-Mate Jr. * attach­
ment.
To Install:
Open the Power-Mate Jr.* storage cover.
Insert the Power-Mate Jr.*, press down into
place, and close the lid securely.
To Remove:
Open the storage cover. Remove Power­
Mate Jr.* from the storage area and use as
needed (see ATTACHMENTS and ATTACH­
MENT USE).
Power-Mate Jr*
Storage Cover