Kenmore 3405602 - Manual (Page 29)

END-OF-CYCLE SIGNAL CONTROL SOFT-HEAT®SYSTEM
for t/our
Benefit
Your dryer sounds a signal when a
drying cycle is finished. The signal
is helpful when you are drying
permanent press, synthetics, and
other items. These items should be
removed from the dryer as soon as
it stops in order to prevent wrinkles.
• The volume of the signal can be
adjusted.
SIGNAL
END O F CYCLE
PUSHTO START BUTTON
Use this control to start the dryer.
Be sure the dryer door is closed.
Opening the door stops the dryer. It
will not start again until you close the
door and press the PUSH TO START
Button. Be sure the Cycle Selector
Control (Timer) is still on a drying cycle
or air setting.
PUSHTO START
for t/oMT Benefit
SOFT-HEAT® System guards against
overdrying. This helps your fabrics
retain the natural moisture they need,
prevents static, and reduces pilling —
the formation of small lint-like balls
on the surface of garments. Pilling
is the natural result of wearing and
washing of garments.
Kenmore dryers help prevent overdrying
so you get outstanding fabric care. In
the AUTO DRY and TIMED DRY Cycles,
clothes are dried at the temperature
you selected until the last few minutes
of the cycle. The dryer then switches to
low heat.
COOL DOWN
Approximately ten minutes before the
end of the AUTO DRY and TIMED DRY
Cycles, clothes are tumbled without
heat to help reduce wrinkles and make
clothes more comfortable to handle.
29