beautypg.com

Kenmore 3405602 User Manual

Page 17

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

STEP 3. Attach a ^A-inch, U.L.-listed,
strain relief to the hole below terminal
block opening . Strain relief should have
a tight fit with dryer cabinet and be in a

horizontal position. Put the power supply
cord through the strain relief.

STEP 4. Remove the center terminal
block screw. Remove the neutral ground­
ing wire (green/yellow wire) from external

grounding screw.

STEP 5. Connect neutral grounding wire
and the neutral wire (white) of power
supply cord under the center screw of
terminal block.

STEP 6. Connect the other two insulated
wires to outer terminal block screws.

STEP 7. Connect the green, grounding
wire from the power supply cord to the
external grounding conductor screw.
Tighten all terminal block screws firmly.

STEP 8. Tighten the strain relief screws.

STEP 9. Insert tab of terminal block
cover into slot of the dryer rear panel.
Secure cover with hold-down screw.

Proceed with Exhaust Installation.
See “CONNECT EXHAUST” on
page 19.

of harness

Center silver-

1 7