Kenmore 116.34924 - Manual (Page 9)

TELESCOPIC WAND WITH
SUCTION CONTROL SLIDE
1. Remove the
hose from the
hose clip by
pulling straight
out.
2. Remove the telescopic wand from its
storage position.
Crevice
Tool
Telescopic
Wand
3. Remove ^
the crevice
tool from its
storage posi- .
tion in the
wand. Turn
the locking
ring to the
UNLOCK
position.
4. Extend the wand to its full length. Turn
the locking ring to the LOCK position.
Attach the extension wand onto the open
end of the hose.
Lower
Wand
Suction
Control Slide
Wand
\Locklng Ring
Upper
Wand
Align the tabs on the extension wand with
the “J” slots in the hose (as illustrated above
right). Push the wand into the hose and
twist to the right to lock.
To achieve maximum reach
with the attachments, add the
crevice tool to the end of the
wand by inserting and
twisting slightly.
Suction
Control
Slide
Tool
Telescopic
Wand
Crevice
The dusting brush or the combination
brush may be attached directly to the
wand or placed on the end of the crevice
tool.
Dusting Brush
(Some Models)
I
—
Combination
Brush (Some
Models)
Brush
TO OPERATE SUCTION
CONTROL SLIDE
Telescopic Wand
When using attachments for cleaning
draperies, small rugs with low pile and other
delicate items, twist the suction control slide
to the open position. This slide is located on
the telescopic wand, close to the hose.
This will reduce suction for ease of cleaning.
Note; Return
suction control
slide to the closed
position for
normal cleaning.
A
Suction
Control
Slide
1
CAUTION
When using attachments, be careful
not to overextend the stretch hose
when reaching. Trying to reach
beyond the hose stretch capability
could cause the vacuum cleaner to
tip over.